Everything below concerns Thymalfasin. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-02-11. Where a claim depends on a specific study, the study is described rather than over-claimed.
Most published studies on thymosin alpha-1 report changes in immune measurements rather than clinical outcomes, and findings differ across designs and populations. Whether the peptide signals through one defined receptor or through several less specific interactions remains an open question. Its reported circulation half-life of a few hours complicates comparison of dosing schedules across trials. Mechanistic claims are frequently drawn from isolated cell cultures, and how far those results extend to whole organisms is unresolved.
Thymosin alpha-1 is a synthetic peptide of 28 amino acids whose sequence matches the amino-terminal region of prothymosin alpha. The chain is acetylated at its first residue and contains one disulfide bridge between two cysteine residues, which folds the molecule into a compact loop. Its molecular formula, C129H215N33O55, corresponds to a monoisotopic mass of roughly 3,106 daltons. Material used in laboratories is made by solid-phase synthesis rather than isolated from animal tissue.
Identity and purity are assessed with a small set of standard peptide methods. Reversed-phase high-performance liquid chromatography separates the main peak from truncated or oxidized species, and its area percentage is the usual purity measure. Mass spectrometry confirms the observed molecular mass against the expected value, while amino acid analysis or peptide mapping checks composition and sequence. Specifications for research-grade material are often stated as 95 percent or higher, though the exact limit depends on the supplier and the intended use.
Laboratory supplies of the peptide usually arrive as a lyophilized powder in sealed vials. The powder is hygroscopic, so a vial should be allowed to reach room temperature before it is opened to prevent condensation on the contents. Weighing and transfer are best performed in a low-humidity environment with clean tools. Once dissolved, the solution should be mixed gently rather than vortexed, because foaming and shear can reduce recovery of the peptide.
Storage recommendations center on low temperature, dryness, and protection from repeated freezing and thawing. The intact powder is commonly held at 20 degrees below zero Celsius or colder, while a working solution is divided into single-use aliquots to limit freeze-thaw cycles. Buffered saline or phosphate-buffered saline at neutral pH is frequently used as a diluent. Light sensitivity is not well documented, yet amber vials or foil wrapping are common practice for long-term storage of peptide stocks.
| Property | Value | Notes |
|---|---|---|
| Class | Synthetic peptide | 28 residues; not a small-molecule compound |
| Molecular mass | About 3,106 Da | Monoisotopic mass of the unmodified chain |
| N-terminal group | Acetylated serine | Present in both native and synthetic forms |
| Secondary structure | Disulfide-constrained loop | One bridge between two cysteine residues |
| Typical source | Solid-phase synthesis | Early isolates came from bovine thymus extracts |
20世纪70年代，研究者从胸腺提取物中纯化出多种小肽，Tα1是其中被较早表征的一种。最初的制备依赖组织匀浆和层析步骤，产量低且成分复杂。随着固相肽合成技术成熟，实验室和工业界能够生产与天然序列一致的合成版本。合成肽的纯度可达95%以上，并可通过反相高效液相色谱和质谱进行鉴定。这一转变使研究不再依赖动物胸腺来源。
市售的胸腺素α1通常以冻干粉形式提供，溶解后用于注射。其氨基酸组成包括多个酸性残基，因此在中性pH下带负电荷。该肽可溶于水和生理盐水，但在有机溶剂中溶解度有限。储存条件通常为冻干状态下负20摄氏度，溶解后需冷藏并避免反复冻融。常见的同义词包括胸腺肽α1、thymalfasin和Tα1。
胸腺素α1（thymosin alpha 1，Tα1）是一种由28个氨基酸组成的酸性肽，N端被乙酰化，分子量约为3108道尔顿。该肽最早从牛胸腺组织提取物中分离，属于胸腺素组分5的一个成分。其序列在不同哺乳动物中高度保守，提示其具有基本的生物学功能。名称中的“α1”指其在电泳中的迁移位置，并非表示亚型编号。它既存在于胸腺，也存在于脾脏和淋巴结等免疫组织。
Thymosin alpha 1 is a 28-amino-acid peptide first isolated from thymosin fraction 5, a bovine thymic extract. Its sequence begins with an acetylated serine residue and carries a high proportion of acidic residues, so the molecule has a net negative charge near neutral pH. Despite the shared name, it is unrelated in sequence to the thymosin beta family. Synthetic material prepared by solid-phase peptide synthesis is identical in sequence to the natural peptide.
Several names appear in the literature for this peptide, including thymalfasin and the abbreviation T-alpha-1. Naming conventions differ among research articles, regulatory documents, and supplier catalogs, which complicates literature searches. Both synthetic and recombinant production routes yield a peptide with the same 28-residue sequence as the thymic isolate. Because the thymosin label also covers unrelated peptides, sources should be compared by sequence rather than by name alone.
Thymosin alpha-1 is a synthetic peptide of 28 amino acid residues that corresponds to a naturally occurring fragment first isolated from thymus tissue. Its chain is acetylated at the amino terminus, a modification that shields the peptide from rapid cleavage by aminopeptidases. The molecule carries a net negative charge at physiological pH and dissolves freely in water. Researchers classify it as an immune-modulating agent rather than a classical hormone, because it acts on several cell types of both the innate and the adaptive immune system.
The peptide was identified during work in the 1970s on thymosin fraction 5, a partially purified extract of calf thymus. Investigators separated that mixture and characterized individual components, one of which they named thymosin alpha-1. The same compound later received the international nonproprietary name thymalfasin. Commercial material is produced by solid-phase peptide synthesis rather than by extraction, so synthetic and natural forms share an identical sequence. Naming conventions vary across the literature, and readers should distinguish the alpha-1 peptide from other thymosins that have unrelated sequences and functions.
Thymosin beta-4 is a separate 43-residue peptide that binds actin and participates in cell migration; it shares no sequence similarity with thymosin alpha-1 despite the common family name. Other preparative materials, such as thymosin fraction 5 and thymopoietin, contain distinct mixtures or peptides. The shared thymosin label reflects the tissue of origin used in early purification, not a common structural core. Treating these molecules as interchangeable is a frequent source of confusion in laboratory reports and in popular summaries alike.
Elimination of protruding knobs and controls in passenger compartment Additional padding on the instrument panel and other interior surfaces Mounting points for front outboard shoulder belts Four-way hazard flashers A uniform P-R-N-D-L gear sequence for automatic transmission gear selectors Dual-circuit brake hydraulic systems In 1968, the precursor agency to the US National Highway Traffic Safety Administration's first Federal Motor Vehicle Safety Standards took effect. These required shoulder belts for left and right front-seat vehicle occupants, side marker lights, collapsible steering columns, and other safety features. 1969 saw the addition of head restraints for front outboard passengers, addressing the problem of whiplash in rear-end collisions. These safety requirements did not apply to vehicles classified as "commercial," such as light-duty pickup trucks. Thus, manufacturers did not always include such hardware in these vehicles, even though many did passenger-car duty. Volvo developed the first rear-facing child seat in 1964 and introduced its own booster seat in 1978.
Plant breeding started with sedentary agriculture and particularly the domestication of the first agricultural plants, a practice which is estimated to date back 9,000 to 11,000 years. Initially early farmers simply selected food plants with particular desirable characteristics, and employed these as progenitors for subsequent generations, resulting in an accumulation of valuable traits over time. Grafting technology had been practiced in China before 2000 BCE. By 500 BCE grafting was well established and practiced. Gregor Mendel (1822–84) is considered the "father of genetics". His experiments with plant hybridization led to his establishing laws of inheritance. Genetics stimulated research to improve crop production through plant breeding. Selective breeding played a crucial role in the Green Revolution of the 20th century. Modern plant breeding is applied genetics, but its scientific basis is broader, covering molecular biology, cytology, systematics, physiology, pathology, entomology, chemistry, and statistics (biometrics). It has also developed its own technology.
Enzyme specificity refers to the interactions between any particular enzyme and its corresponding substrate. In addition to the specificity in binding its substrates, correct proximity and orientation as well as binding the transition state provide an additional layer of enzyme specificity. Enzymes vary in the specificity of the substrates that they bind to, in order to carry out specific physiological functions. Some enzymes may need to be less specific and therefore may bind to numerous substrates to catalyze a reaction. On the other hand, certain physiological functions require extreme specificity of the enzyme for a single specific substrate in order for a proper reaction and physiological phenotype to occur. The different types of categorizations differ based on their specificity for substrates. Most generally, they are divided into four groups: absolute, group, linkage, and stereochemical specificity.
Albumin is a family of globular proteins, the most common of which are the serum albumins. All of the proteins of the albumin family are water-soluble, moderately soluble in concentrated salt solutions, and experience heat denaturation. Albumins are commonly found in blood plasma and differ from other blood proteins in that they are not glycosylated. Substances containing albumins are called albuminoids. A number of blood transport proteins are evolutionarily related in the albumin family, including serum albumin, alpha-fetoprotein, vitamin D-binding protein and afamin. This family is only found in vertebrates. Albumins in a less strict sense can mean other proteins that coagulate under certain conditions. See Other albumin types for lactalbumin, ovalbumin and plant "2S albumin". Albumins in general are transport proteins that bind to various ligands and carry them around. Human types include:
CGRP antagonists can be used for both acute migraine treatment as well as prophylactically. CGRP is a neuropeptide which is thought to induce migraines via vasodilation of cranial arteries. CGRP can also release inflammatory agents and cause nervous system sensitization. It is theorized that by antagonizing the CGRP receptor of the trigeminal ganglia, lowered CGRP is released and less migraine occurs. Erenumab is a highly selective human monoclonal antibody which is a promising new development in migraine treatment. It has low risk of hepatoxicity like gepants can have, due to being mostly eliminated via proteolysis. There have been some studies suggesting the benefit of using melatonin for prophylaxis of migraine, however, there is a lack of strength of evidence due to a low number of studies as well as conflicting results. Melatonin has a good safety profile but there have been rare instances of serious side effects. More studies are needed in order to suggest the therapeutic use of melatonin for prophylaxis of migraine.
Sources: en.wikipedia.org
The F1 portion of ATP synthase is hydrophilic and responsible for hydrolyzing ATP. The F1 unit protrudes into the cytoplasm (matrix and stroma in mitochondria and chloroplasts respectively). Subunits α and β make a hexamer with 6 binding sites. Three of them are catalytically inactive and they bind ADP. Three other subunits catalyze the ATP synthesis. The other F1 subunits γ, δ, and ε are a part of a rotational motor mechanism (rotor/axle). The γ subunit allows β to go through conformational changes (i.e., closed, half open, and open states) that allow for ATP to be bound and released once synthesized. The F1 particle is large and can be seen in the transmission electron microscope by negative staining. These are particles of 9 nm diameter that pepper the inner mitochondrial membrane.
Automated synthesis or automatic synthesis is a set of techniques that use robotic equipment to perform chemical synthesis using a robotic system run using software control. Automating processes allows for higher efficiency and product quality although automation technology can be cost-prohibitive and there are concerns regarding overdependence and job displacement. Chemical processes were automated throughout the 19th and 20th centuries, with major developments happening in the previous thirty years, as technology advanced. Tasks that are performed may include: synthesis in variety of different conditions, sample preparation, purification, and extractions. Applications of automated synthesis are found on research and industrial scales in a wide variety of fields including polymers, personal care, and radiosynthesis.
The Bailey peptide synthesis is a name reaction in organic chemistry developed 1949 by J. L. Bailey. It is a method for the synthesis of a peptide from α-amino acid-N-carboxylic acid anhydrides (NCAs) and amino acids or peptide esters. The reaction is characterized by short reaction times and a high yield of the target peptide. The reaction can be carried out at low temperatures in organic solvents. The residues R1 and R2 can be organic groups or hydrogen atoms, R3 is the used amino acid or peptide ester: The reaction mechanism is not known in detail. Supposedly, the reaction begins with a nucleophilic attack of the amino group on the carbonyl carbon of the anhydride group of the N-carboxylic acid anhydride (1). After an intramolecular proton migration, a 1,4-proton shift and the cleavage of carbon dioxide follows, resulting in the peptide bond in the final product (2):
The advantage in atom economy of using NCAs for peptide formation is that there is no need for a protecting group on the functional group reacted with the amino acid. For example, the Merrifield synthesis depends on the use of Boc and Bzl protecting groups, which need be removed after the reaction. In the case of Bailey peptide synthesis, the free peptide is directly obtained after the reaction. However, unwanted and difficult to remove by-products may be formed. An N-substitution of the NCA (for example, by an o-nitrophenylsulfenyl group) can simplify the subsequent purification process, but on the other hand deteriorates the atom economy of the reaction. The synthesis of NCAs can be carried out by the Leuchs reaction or by the reaction of N-(benzyloxycarbonyl)-amino acids with oxalyl chloride. In the latter case, again the procedure is less efficient in the sense of atom economy. The following peptides were synthesized using this method by 1949:
Sources: en.wikipedia.org
Its sequence corresponds to the amino-terminal portion of prothymosin alpha, a larger protein present in many cell types. The isolated 28-residue peptide is a fragment of that protein rather than a separately encoded molecule, and laboratory material is produced by synthesis.
The single bridge between two cysteine residues holds the chain in a folded loop that influences its shape and its behavior in solution. Loss of the bridge through reduction or oxidation shifts chromatographic retention and is tracked during stability work.
It is a defined 28-residue sequence derived from a larger precursor, whereas many other thymic preparations are mixtures of several polypeptides. Its acetylated amino terminus and single disulfide bridge distinguish it chemically from unrelated thymic extracts.
Aliquots are typically frozen well below zero Celsius and thawed only once, since repeated cycles promote aggregation and loss. Dilution into a neutral buffer limits degradation during short working periods, and prolonged storage at room temperature is avoided.